How to Clean Dog Collars

Using Baking Soda

Mix baking soda and water. Stir in a small spoonful of baking soda into hot water until it dissolves. This mixture can be used to clean all common types of dog collars. Always remove the collar from the dog before cleaning.

Scrub the dog collar with this mixture. Dip a toothbrush into the mixture and scrub the collar.

Rinse. Hold the collar under running water to remove the cleaning mixture.

Let dry. Either place on a towel to dry, or hang the collar away from direct sunlight. The collar should be nice and clean again now. If the collar is leather, do not dry near a strong heat source or in direct sunlight, as this may cause the leather to crack.

Using Peppermint Soap

Use this method to remove scent from leather collars. This is great for leather collars that have taken a swim with Fido in stinky water.

Lather up the peppermint soap. Remove the collar from the dog, then coat the collar with the lather.

Scrub the collar with a toothbrush. Remove visible grime and try to cover all of the collar to help lift the odor.

Rinse in very hot water. Once rinsed, sniff the collar to see if it smells better. If not, soap and rinse again, then repeat the process until the odor is gone.

Let dry. Either lay on a towel to dry or hang it up and air dry out of direct sunlight. Hopefully the collar smells a whole lot better now!

Using the Dishwasher

Use with non-leather collars only. Leather should not be put through the dishwasher, but many other types of dog collars and leashes can be cleaned this way.

Place the collar on the top rack of the dishwasher. Clip to the rack to prevent it from slipping off during the wash.

Put through a normal wash cycle. You may need to hang the collar to finish drying afterward.

Cleaning Synthetic Collars

Use this method for nylon or polyester collars. These cleaning materials may damage collars made from natural materials, including cotton, wool, and leather. However, they are both effective options for removing grime and odor from synthetic materials. An alternative method for synthetic collars would be to add them to a load of laundry in the washer/dryer. The detergent, hot water and heat from the dryer all help to sanitize the collar/leash. There is a padded/porous bag available that will eliminate the banging/clanging noise and protect the washer/dryer and other items in your load. Take the collar off the dog before you get started.

Try vinegar and baking soda. Make a solution of equal parts white vinegar and baking soda. Soak the collar for 15 to 30 minutes.

Use hydrogen peroxide instead. Alternatively, you can submerge the collar in hydrogen peroxide for about an hour.

Wash out the cleaning solution. Rinse out the collar after it's done soaking. Wash it in soapy water if you used hydrogen peroxide.

Let dry. Shake gently to remove some water, then place on a towel or hang it up to air dry.